VENSEAL™

Installation Guide

How to Apply VENSEAL™ Tyre Sealant

Before You Begin

⚠️ Safety First

Wear eye protection during installation
Work in a well-ventilated area
Keep out of reach of children and pets
Do not use on fully worn-out tyres
Have water ready for cleanup in case of spills

What You'll Need:

• VENSEAL™ bottle (500ml)
• Tyre pressure gauge
• Valve core removal tool (optional but helpful)
• Air compressor or pump
• Gloves and eye protection
• Cloth for cleanup

Step-by-Step Installation

Shake the Bottle

Shake the VENSEAL™ bottle vigorously for 30-60 seconds to ensure the sealant is properly mixed.

Position the Valve

Position the tyre valve at the bottom (6 o'clock position) to make application easier.

Remove the Valve Core

Using a valve core removal tool, unscrew and remove the valve core. If you don't have a tool, you can inject through the valve without removal, but it will be slower.

Attach the Applicator

Attach the hose from the VENSEAL™ bottle to the valve stem. Ensure it's securely connected.

Inject the Sealant

Squeeze the bottle firmly to inject the sealant into the tyre. Apply the recommended dosage (see table below).

Reinstall the Valve Core

Once the sealant is injected, reinstall the valve core and tighten it securely.

Inflate the Tyre

Inflate the tyre to the recommended pressure as specified by your vehicle manufacturer.

Distribute the Sealant

Drive the vehicle immediately for at least 5-10 minutes to distribute the sealant evenly inside the tyre.

Recommended Dosage

Vehicle Type	Front Tyre	Rear Tyre	Total per Vehicle
Scooters	250ml	250ml	500ml (1 bottle)
Bikes below 125cc	250ml	300ml	550ml (1 bottle + a little extra)
Bikes above 125cc	300ml	400ml	700ml (1.5 bottles approximately)
Cars (small)	500ml	500ml	2000ml (4 bottles)

💡 Pro Tip

For best results, apply VENSEAL™ to clean, dry tyres. The sealant works best when applied to tyres in good condition with minimal wear.

After Installation

• Check tyre pressure regularly for the first 48 hours
• The sealant will coat the inside of the tyre and will instantly seal any punctures up to 4mm
• For existing punctures, you may need to briefly inflate the tyre to allow the sealant to work
• The sealant will typically last for the life of the tyre or up to 2 years
• If you need to add air to your tyres, do so as normal - the sealant won't affect inflation

Troubleshooting

Problem: Sealant is difficult to inject

Solution: Ensure the valve core is removed completely. Shake the bottle more vigorously and try again.

Problem: Tyre won't hold air after application

Solution: The puncture might be larger than 4mm, or the tyre may have sidewall damage. Please consult a tyre professional.

Problem: Sealant leaks when attaching to valve

Solution: Ensure the connection is tight. You may need to replace the valve stem if it's damaged.

Need Help With Installation?

Our customer support team is available to assist you with any questions:

VENSYS GROUP
Email: vensealonline@gmail.com
Phone: +91 8754467478
Hours: Monday-Saturday, 9:00 AM - 6:00 PM IST

Back to VENSEAL Website